  |
|
|
Legion LSA-2000
Details
This 2700 watt power amplifier has a built in switch for a 150hz low pass crossover as well as a 40hz
low pass filter to protect your subwoofers from over excursion due to extremely low frequencies.
Either can be turned on or off at anytime so it can function normally. It has high pass outputs so if
you do run the 150hz crossover, you can output to another power amplifier for main PA speakers
and they will only receive 150hz and above. It’s a built electronic crossover option that saves time,
rack space, ease and money. Full frequency pass through outputs are also included.
The Thermal heat sensor is located at the end of the heat sink block for each channel, allowing the
fans to cool both ends of the heat sinks. Some may have a special term for this or “name” but it’s
all the same and is good technology.
This amp uses 2700 watts worth of transistors and has the power supply and transformer to back
them up fully. This is honest to goodness power and quality.
It is a solid design with strong handles, rear rack ears and plenty of structure to hold up under
harsh road conditions. It utilizes a metal plate on top of the transformer that is bolted in place.
When dealing with large transformers, this is a key feature if the amp is moved around a lot.
Key Features
XLR / ¼” hybrid inputs
¼” pass through outputs
¼” high pass through outputs
Banana and Speakon speaker outputs.
Voltage selector
Ground lift switch
Dual recessed gain controls
Left and right 150hz crossover switches (18db per octave)
Left and right Low Cut (40hz) crossover switches
Dual 2 speed 3” cooling fans (air flow front to back)
Protection includes: short, open, thermal, RF and ohm load.
Rubber feet
1 year warranty
Specs
750 x 2 at 8ohm
1000 x 2 at 4ohm
1350 x 2 at 2ohm
2000 x 1 at 8ohm (mono)
2700 x 1 at 4ohm (mono)
S/N Ratio: 100db
Distortion: Less than .01%
THD: Less than .03%
Frequency response: 5hz to 50khz at rated output
Damping Factor: Greater than 300
2 space rack unit, 14.5” deep
50LBS